ThyElite Forums - Smoke bombs ect..

TeH PypE h4nD Gr3naDe:
Code:
Pipe Hand Grenade                           



          Hand  Grenades  can  be  made  from  a piece of iron pipe. The

      filler  can  be  of  plastic  or  granular   military   explosive,

      improvised  explosive,  or  propellant  from shotgun or small arms

      munition.



      Material Required:

      -----------------



      Iron Pipe, threaded ends, 1-1/2" to 3" diameter, 3" to 8" long.

      Two (2) iron pipe caps

      Explosive or propellant

      Nonelectric blasting cap (Commercial or military)

      Fuse cord

      Hand Drill

      Pliers



      Procedure:

      ---------



      1) Place blasting cap on one end  of  fuse  cord  and  crimp  with

      pliers.



      NOTE: To find out how long the fuse cord should be, check the time

      it takes a known length to burn. If 12 inches burns in 30 seconds,

      a 6 inch cord will ignite the grenade in 15 seconds.



      2)  Screw  pipe  cap  to one end of the pipe. Place fuse cord with

      blasting cap into the opposite end so that  the  blasting  cap  is

      near the center of the pipe.



      NOTE:  If  plastic  explosive  is  to  be  used,  fill pipe BEFORE

      inserting blasting cap. Push a round stick into the center of  the

      explosive to make a hole and then insert the blasting cap.



      3)  Pour explosive or propellant into pipe a little bit at a time.





      Tap the base of the pipe frequently to settle filler.



      4) Drill a hole in the center of  the  unassembled  pipe  caplarge

      enough for the fuse cord to pass through.



      5)  Wipe  pipe  threads  to  remove any filler material. Slide the

      drilled pipe cap over the fuse and screw handtight onto the pipe.



      Ready to go!